PRODUCT FILTER
Form Factor
Features & Functions
Cooling
Product Status
Temperature Range
  • 16 Channels D/A
  • Settling Time: 2 μs
  • Output Range: 0-5V
  • Programmable Output Ranges per Channel: Six
  • Output Drive: Up to 30 mA
  • Output Specifications:
  • Resolution: 16 bits
  • Settling Time: 700 ns (typical)
  • Low Offset: 125 μV (typical)
  • Offset Drift: 0.35 μV/°C (typical)
  • Unipolar Modes: 0V to 5V, 0V to 10V
  • Bipolar Modes: ±5V, ±10V, ±2.5V, -2.5V to 7.5V
  • 8 Channels D/A
  • 1 μS settling time, 0-5V range
  • 16 Bits Resolution
  • 2- or 4-quadrant, 6.8 MHz BW multiplying DAC
  • ±1 LSB DNL ±1 LSB INL
  • Low noise: 12 nV/√Hz
  • Built-in 4-quadrant resistors allow 0 V to –10 V, 0 V to +10 V, or ±10 V outputs
  • Selectable zero-scale/midscale power-on presets per channel
  • Up to 30 mA Output Drive
  • Front Panel 68-pin MDR Connector
  • AXM interface board
  • 30 Differential Lines
  • Direction Controlled by Channel
  • RX 120 Ohm Terminators
  • 20Mbps Maximum Data Rate
  • No Damage or Latchup Up to ±25kV
  • High Input Impedance Supports 256 Nodes
  • Guaranteed Failsafe Receiver Operation Over the Entire Common Mode Range
  • Compatible with TIA/EIA-485-A Specifications
  • Fully Compatible with AXM-D02-JTAG
  • Front Panel 68 pin SCSI Connector
  • AXM interface board
  • 64 I/O Channels
  • Switch between 3.3-V LVTTL and 5V JEDEC standards (JESD8C.01)
  • Translate the two standards into an LVCMOS JEDEC standard for the FPGA pin connections
  • 64 I/O can be programmed to have resistors that pull the IO pins to the programmed VCC, or ground in banks of 8
  • Power-up Controller to allow Pull-up or Pull-down
  • Front Panel MDR Connector
  • AXM interface board
  • 4 Differential Lines
  • Control line (OE) Output Enable
  • RX 120 Ohm Terminators
  • 4 RS-232 Interface
  • Front Panel 68 pin SCSI Connector
  • 1 or 2 controllers of dual redundant (A/B channel) 1553 communications
  • Programmable bus controller, remote terminal, or monitor terminal modes
  • MIL-STD-1553 A and B compliant, Notice 2 RT
  • STANAG 3838, McAir A3818, and General Dynamics 16PP303 compatible
  • BC/RT/MT mode
  • 64K words internal RAM with parity
  • Long or short stub support
  • Front panel I/O
Scroll to Top

User Manual Request

Please submit your information & we will send you a link and password to access our product manual. 

Please submit your information & we will send you a link and password to access our product manual. 

Already have a password? Visit manuals page below.

Already have a password?
Visit manuals page below.