PRODUCT FILTER
Form Factor
Features & Functions
Cooling
Product Status
Temperature Range
- 16 Channels D/A
- Settling Time: 2 μs
- Output Range: 0-5V
- Programmable Output Ranges per Channel: Six
- Output Drive: Up to 30 mA
- Output Specifications:
- Resolution: 16 bits
- Settling Time: 700 ns (typical)
- Low Offset: 125 μV (typical)
- Offset Drift: 0.35 μV/°C (typical)
- Unipolar Modes: 0V to 5V, 0V to 10V
- Bipolar Modes: ±5V, ±10V, ±2.5V, -2.5V to 7.5V
- 8 Channels D/A
- 1 μS settling time, 0-5V range
- 16 Bits Resolution
- 2- or 4-quadrant, 6.8 MHz BW multiplying DAC
- ±1 LSB DNL ±1 LSB INL
- Low noise: 12 nV/√Hz
- Built-in 4-quadrant resistors allow 0 V to –10 V, 0 V to +10 V, or ±10 V outputs
- Selectable zero-scale/midscale power-on presets per channel
- Up to 30 mA Output Drive
- Front Panel 68-pin MDR Connector
- AXM interface board
- 30 Differential Lines
- Direction Controlled by Channel
- RX 120 Ohm Terminators
- 20Mbps Maximum Data Rate
- No Damage or Latchup Up to ±25kV
- High Input Impedance Supports 256 Nodes
- Guaranteed Failsafe Receiver Operation Over the Entire Common Mode Range
- Compatible with TIA/EIA-485-A Specifications
- Fully Compatible with AXM-D02-JTAG
- Front Panel 68 pin SCSI Connector
- AXM interface board
- 64 I/O Channels
- Switch between 3.3-V LVTTL and 5V JEDEC standards (JESD8C.01)
- Translate the two standards into an LVCMOS JEDEC standard for the FPGA pin connections
- 64 I/O can be programmed to have resistors that pull the IO pins to the programmed VCC, or ground in banks of 8
- Power-up Controller to allow Pull-up or Pull-down
- Front Panel MDR Connector
- AXM interface board
- 4 Differential Lines
- Control line (OE) Output Enable
- RX 120 Ohm Terminators
- 4 RS-232 Interface
- Front Panel 68 pin SCSI Connector